Nissan Versa Forums banner
1 - 3 of 8 Posts

· Registered
Joined
·
21 Posts
It looks as though but can't really be certain, that some of these aftermarket armrests I have seen on eBay may fit, assuming the rear cup holders size is the same as the ones advertised. I have seen a few for the '09-'11 model years where it appears the setup would be the same in the '15 model...attaching to the cup holder. Some of them advertised I noticed were in the $35 range...and the same ones selling up to $60-70 elsewhere. I read through the instructions on these and they come with 8 screws. 4 screws for the base and 4 screws for the console attaching to the base. The instructions don't specify, but I am assuming the base mount screws must go directly into the cup holder, so if you ever decide for whatever reason to remove it you are stuck with 4 little holes in your cup holder. I guess you could always cut a circular small piece of felt or thin rubber material and cover that if needed...assuming the thing is really a piece of crap and you got just wanted it out. I was wondering how stable that contraption would be screwed into the cup holder? It could turn wobbly on you quick?

Toward the bottom of the listing there is a link to snap-guide which goes through the installation: Nissan Versa Note Black Armrest Center Console 2014 5DH Hatchback Brand New | eBay

This one above says does not fit Sedan.

Here, this fits states fits 07-11 Sedan an appears to be the exact same unit: http://www.ebay.com/itm/Nissan-Versa-Armrest-Center-Console-07-11-Sedan-07-13-5DH-Hatchback-HB-Brand-New-/151353759441?pt=Motors_Car_Truck_Parts_Accessories&hash=item233d6316d1&vxp=mtr

I guess the best choice would just be to wait until something shows up the clearly states will fit the '15 Sedan.
 

· Registered
Joined
·
21 Posts
Okay, update...

It allows you to drill four holes in the bottom of the cup holder, which I have not done yet, but even with a tight fit, it does move around, so I will be drilling four holes to bolt it in. ...
How did it go? When you put the screws into the cup holder was there any issues there like the plastic stripping out and the screw free turning? Does it feel tight and secure after screwing it down?

Thanks,
Charlie
 
1 - 3 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top