[versamack04]

Hey Guys,

I have an electronic autometer temperature gauge from an old project car i had. I was wondering if anyone knew where i would be able find a plug to install the temperature sensor for the gauge on the engine? also if anyone has ideas where to mount the gauge, its a 52mm gauge. Any thoughts or ideas are appreciated.

Thanks in advance.

 

[jswilson1987]

Silver 30mm 1 18 inch Water Temp Temperature Adaptor Adapter Gauge Radiator Hose | eBay

These get spliced into the radiator hose. Then the sending unit gets screwed into it and a ground ran.

 

[versamack04]

Great thanks!

 

[jswilson1987]

Just make sure you measure the hose first

 

[jswilson1987]

and heres a mount
52mm 2 inch Universal Gauge Dash Mount Pod Holder Boost Water Volt Gauge | eBay

or
http://www.ebay.com/itm/52mm-UNIVERSAL-SINGLE-GAUGE-A-PILLAR-POD-POST-HOLDER-/350789023405?pt=Motors_Car_Truck_Parts_Accessories&hash=item51aca7b6ad&vxp=mtr

 

[Tubtub]

Just get a universal mount and put on the A pillar

 

[versamack04]

I was wondering the best place, i was either thinking A pillar or just about the gauge cluser on the dash....anyone else have any ideas? And will definatly check the rad hose size before cutting haha.

 

[Tubtub]

If you have the money Id say buy a scangauge II

 

[versamack04]

Will do thanks, I'm also wondering about the dash lights behind the gauges. Anyone know if they are the same as the center consol lights, #74's, or are they different.