Nissan Versa Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
339 Posts
Discussion Starter · #1 · (Edited)
Im planning on putting a couple gauges on the a pillar(water temp, oil pressure). Of course the CTS is on the water pump and the OPS is also in a fubar spot. So im thinking of using one of these over the OBD box(I prefer analog type gauges were i can see a sweep). I just need to know if anyone knows the hose size. And thread pitch fore the oil filter is 20 x 1.5mm





 

·
Administrator
Joined
·
5,024 Posts
I'd stay away from the oil filter sandwich and just "T" a fitting from the oil pressure sender to the oil pressure gauge. Its mucho easier.
 

·
Registered
Joined
·
339 Posts
Discussion Starter · #3 · (Edited)
I was thinking about that this is were the OPS is



and this is were the CTS is



neither area i want to do that much work in i have huge hands
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top