Nissan Versa Forums banner
1 - 1 of 6 Posts

· Registered
925 Posts
Hi everyone,

I'm new here but I was hoping some of you more experienced Versa-owners could help me with an issue I'm having.

I'm trying to replace my brake pads. I bought everything (OE Spec pads, brake cleaner, caliper lube) at the local parts store last week, then when this past weekend came around I was all set to go. I took off my left tire, then got my socket wrench out and tried to loosen up the bottom caliper pin. The thing didn't budge AT ALL, no matter how much I tried.

Now the area is a bit corroded, so I figured a bit of PB Blaster would do the trick. Over the course of an hour I applied it four times. Even after doing that the thing didn't budge.

Has anyone else run into this issue? Does anyone know what else I could do, or any other ideas?

Thanks very much in advance.
There is also a product carried in parts stores call Freeze-Off. I have used it with good results. As with both products, time is required for them to work. The other option, if you have the clearance necessary would be to use an impact wrench. There are some electric ones that sell for about $25 that will do the trick when all other options are exhausted. Another option would be to give the pin a sharp rap with a light hammer. That sometimes will help in breaking up the corrosion and rust. Good luck
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.