Nissan Versa Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I am having a problem with my 2008 Versa HB. I replaced the clutch, but i am having a hard time bleeding the clutch. I have used the FSM procedure with no luck. This is the car I have to use for work! So I need help quick...
Thanks in advance
 

·
Registered
Joined
·
3 Posts
I am having a problem with my 2008 Versa HB. I replaced the clutch, but i am having a hard time bleeding the clutch. I have used the FSM procedure with no luck. This is the car I have to use for work! So I need help quick...
Thanks in advance

Hi did you ever get the clutch to bleed? We have a problem after replacing the clutch the fluid keeps pushing out of the nipple by clutch and dose not build up! Any help would be great please?
 

·
Registered
Joined
·
208 Posts
I can't find it now, but if I recall correctly, I believe it's an issue with an O-ring being shifted out of place on the slave cylinder? Problem is, doesn't the transmission have to come back out to get at the slave cylinder?
 

·
Registered
Joined
·
3 Posts
I can't find it now, but if I recall correctly, I believe it's an issue with an O-ring being shifted out of place on the slave cylinder? Problem is, doesn't the transmission have to come back out to get at the slave cylinder?
We did replace the slave cylinder with the clutch so don't think it could be that. And it is a concentric slave cylinder! Yes the gearbox must come out again then but don't think that is the problem. And all that comes out of nipple is air and fluid but as I said it never builds up on bleed stays flat to the floor!
 
1 - 4 of 4 Posts
Top