[deaftosociety]

anybody know the torque specs for the exhaust manifold i just picked up the obx header so i was wondering?

 

[Hschlick84]

127 lb-ft @ 4800 rpm

 

[deaftosociety]

do you want me to break off a bolt into my block?

 

[Hschlick84]

I wouldnt suggest doing it

 

[deaftosociety]

i can run the flexpipe here unlike most of the people on this forum thank you for your suggestion but i will take my chances if it dosent work i can buy a build a header kit from summit and make my own if its that big of a problem which it wont be.

 

[localnemesis]

hehehehe that made me laugh lol 127lb hehehe jk

 

[#1Tango]

i messaged you on facebook the info

 

[APLPIX]

127 lb-ft @ 4800 rpm

LMAO damn, i gotta spin my arms that fast eh :chuckle:

 

[stillhere153]

equal to the amount of lbs tq it takes to make ur nipples bleed ahahahaah

 

[blindsnyper]

127 lb-ft @ 4800 rpm

 

[Hschlick84]

Sorry guys, I misread what you posted. I looked at the FSM and it says 33.4 lbs. The stud bolt is 12 lbs. Again, my fault.

 

[stillhere153]

Well technically he was correct

Those are the Torque Specs... Just the wheel torque specs... I just got that now... Doh

 

[deaftosociety]

decided to take it to the shop that i trust to work on my versa price for install is a little steep but hopefully itll be less

 

[deaftosociety]

took the header to a shop got it on no problems found out i have a leaky intake manifold gasket so im gona have to get that swapped out next week