Inaccurate Gas Gauge
1 - 4 of 4 Posts
Joined
·
78 Posts
Sounds like an issue with the fuel sending unit. Either the float is bent or the sensor tied to the float in the tank went bad.
Is your Versa still under warranty?
Is your Versa still under warranty?
Joined
·
78 Posts
with out hearing the noise in person my best guess is a bushing in the front might be going bad.
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
Frequent tail-light failures?
General Technical & ElectricalCalling all Versa electrical experts!! I love my 2007 Versa hatchback, which I've had about three years now, but there are a couple of things that drive me crazy. One is (I bet you can guess) the darned TPMS indicator light that never goes out.. another is the rear wiper that I cannot figure...- 10
- 9K
-
Which Replacement Battery?
General Technical & ElectricalHello, My GF took her 2009 Versa Base to the dealership for routine oil change and the 21 point inspection. They said the battery needs to be replaced, it is the original one. To save money, I will replace the battery myself as dealership wanted $158. However, after reading this thread, I...- 22
- 95K
-
Maintenance opportunities
General Technical & ElectricalI recently acquired an 07 Versa S with a CVT and 140k miles. Up until now it has basically only had oil changes, tires, and brakes. I want to start driving it daily to save costs on fuel. Any recommendations on things I need to do? So far I have done the following, Changed the oil and filter...- 3
- 49
-
O2 Sensor Woes
General Technical & ElectricalWe are working with an 07 Versa S with 140K miles. I have 3 codes P1148, P0031, P0130. I have already replaced the upstream O2 sensor with a with a Denso 234-9070. I have unplugged the negative battery terminal for hours to reset the light and it comes back on instantly. I have also checked the...- 5
- 68
-
2007 Versa clutch bleeder valve won't close
General Technical & ElectricalHi there. The clutch on my 2007 Versa recently started feeling spongy, so I wanted to try bleeding the air out of the lines to see if that would fix the problem. I've connected a tube to the bleeder valve, pumped the clutch pedal, and opened the valve by pushing in the pin and pulling the...- 2
- 78
-
matz6200 · updated
Join now to ask and comment!