[superskunk]

I had to change out my 35W 6000K HID (low beam only) because one of my ballasts went out. so i put in my stock halogen bulbs and when i turned them on only the high beam would work... anyone have any clues as to why this is happening? i was thinking this might go on for a few days, i will report back with my findings...

 

[superskunk]

the bulbs i replaced the HID's with were the same exact bulbs i removed from my headlights prior to installation of the HID kit, i am going to pick up a new ballast tomorrow, so when i install my low beam only HID kit it should go back to normal, but i should check another set of bulbs... and to answer the other question, neither of the bulbs turns on when switched to low beam...

 

[superskunk]

i tried to install the new ballasts but still no power to the low beam, fuses are good... it might be a relay, i have to go visit my friend and run diagnostics