Nissan Versa Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
690 Posts
Discussion Starter · #1 ·
Why in the hell weren't these parts moulded as one part and not the mickey mouse way they did it? Using adhesive on a place that heat cycles so frequently. It's an eyesore on everyones Versa to have that little flap sticking up showing a gap, hell even when that flap is flush with the cowling it still doesn't look good with a seam.

I know someone who has a hobby in ABS plastic moulding/casting and has made a few parts for the 928 community. I doubt most would spring for it but who knows.
 

·
Premium Member
Joined
·
790 Posts
Couldn't agree more. They always pop out, and seem to want to fall off at anytime! I even bought a replacement piece thinking it was just that they went bad, and nope. They still suck. DAMN!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top