if you havent made the hole in the protector. What i did was made it smaller about 3" since the fogs are 3.5" they barely fit and therefore no need for glue.
moutning walmart fogs?
Hey guys, just installed walmart fogs last night. Everything went well, but i just don't know how to mount them. I've been reading around and some people just glue the foglight to the foglight protector itself. Not too sure if i wanna do this because then i won't be able to adjust it.
any ideas? thanks
any ideas? thanks
1 - 7 of 7 Posts
I got Walmart fogs in ours they just kinda fit honestly
i made the hole already. i think i just have to make the hole a little bigger and mount the fogs to the foglight protector. what you guys think?
Thats what I did. I just made the whole smaller then the fog lights
and i shoved them in the protector they dont move at all. no glue no drilling.
and i shoved them in the protector they dont move at all. no glue no drilling.
How do ya make a hole W/O drilling?Thats what I did. I just made the whole smaller then the fog lights
and i shoved them in the protector they dont move at all. no glue no drilling.
Don't mount them to the protector or surround as I call it pop they off and fit them in the holes there for the fogs they'll fit. Then trim protector till it snaps back in place
1 - 7 of 7 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Nissan Versa Forums
We’re a forum community dedicated to Nissan Versa owners & enthusiasts. Come join the discussion on performance, troubleshooting, accessories, purchasing, maintenance and more!
Full Forum Listing
Recommended Communities
