Does anyone know if you can get code without taking it in. My PT Cruiser will give code if you turn ignition key on/off 5 times. Is there a simple reset for light. Yes I know... it's under warranty, but I love to learn any little tricks someone else may have figured out.
SES light on at 23K
1 - 3 of 3 Posts
Joined
·
6,567 Posts
I believe someone did post on here how to get a code.
I'll try to find the thread for you.
I'll try to find the thread for you.
Joined
·
6,567 Posts
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Error code P0705
General Technical & ElectricalHello everyone, For starters: the car I'm driving has less than 30k miles and is a 2014 Nissan Versa 1.6 SV. For the past week or so, I've had the yellow, non-blinking Check Engine Light on. The car seems to be driving perfectly fine, with nothing out of the ordinary. Finally took it in for...- 6
- 12K
-
2008 Versa airbag removal
General Technical & ElectricalI searched the forum and found instructions to remove airbag & steering wheel to replace clockspring (spiral cable). The airbag releases partially when the springs are engaged with a screwdriver, but it will not release fully from the steering wheel. Has anyone encountered this problem, and if...- 23
- 577
-
Screeching coming from engine and hesitation when cold
General Technical & ElectricalHi everyone, I just wanted to get some opinions, since I'm trying to troubleshoot what might be wrong with my Versa. 2009 HB, 1.8L SL automatic transmission. About 137k miles. As per the title, when engine's cold, there is a screeching noise coming from the engine (checked drive belt but...- 7
- 220
-
2016 Nissan Note-only 39,000 km making noise when turning
General Technical & ElectricalSlight noise seems to be coming from right and left wheel area when turning. With such lo mileage I have no clue what this may be??- 18
- 265
-
Marie · updated
-
Clutch Help in No VA.
General Technical & ElectricalI am having a problem with my 2008 Versa HB. I replaced the clutch, but i am having a hard time bleeding the clutch. I have used the FSM procedure with no luck. This is the car I have to use for work! So I need help quick... Thanks in advance- 3
- 1K
Join now to ask and comment!